€0.00
Winkelwagen

Brodit ProClip 530480 Houder - Zwart

Productcode: 530480  |  EAN/UPC: 7320285304802

Gratis
verzending
Brodit 530480 Houders
Brodit 530480 Houders
Brodit 530480 Houders
Brodit 530480 Houders
Brodit 530480 Houders
Brodit 530480 Houders
135,- excl. btw
163,35 incl. btw
Verwachte voorraad datum:
Levertijd onbekend
Gratis verzending!

Schrijf een review en help anderen met hun keuze door jouw ervaring te delen.

Categorie: Houders

Niet op voorraad

Verwachte voorraad datum:

Levertijd onbekend

Ontvang een bericht als dit product op voorraad is

productinformatie

Productbeschrijving

Download PDFBrochure downloaden

Brodit ProClip 530480 Houder - Zwart kenmerken

ProClip 530480, Getac Z710

Brodit ProClip 530480, Tablet/UMPC, Auto, Passieve houder, Zwart, Getac Z710 (EU Version) (For all countries) Getac Z710 (US Version) (For all countries)

Passive holder with tilt swivel
Fits unit both with and without handstrap.
With your Getac in a holder attached in your vehicle you will always have it within easy reach. Safe, neat and convenient! You can connect e.g. a charging cable to the device when it is in the holder.

The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the device into place in the holder, and to take it with you when leaving the vehicle.

INSTALLATION INSTRUCTIONS:
Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

3. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into place in the holder. To remove the device from the holder: Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.

4. The holder is in place.